Precautions for the use of hydraulic breaker

The crushing hammer adopts the optimum design idea, enlarges the stroke of the piston and the cylinder body, uses the same big diameter of the piston and the brazing rod, so that the matching effect of the hammer and the main engine is better, the higher output energy is reasonably used, the energy is saved and the work efficiency is the highest. Here is a brief introduction to the problems you need to pay attention to when using broken hammer.

1. When running broken work, please confirm that the direction of the drill rod is perpendicular to the surface of the broken object and keep it at any time. If it is inclined to the surface of the broken object, the rod may slip from the surface. In this case, the rod will be damaged and the piston will be affected. In case of breakage, select the appropriate strike point and confirm that the drill rod is solid enough to strike again.

2, do not use broken hammer fittings, steel drill or mill side to move or push stones. At this time, the oil pressure comes from the excavator, loader arm and small arm. Shovel, rocking or sliding manipulation, so the arms will be damaged, while the broken hammer bolts may break, the support will be damaged, the steel can break or scratch, and the broken hammer should be avoided to remove the stones. In particular, it is pointed out that the steel drill should be inserted in stone and must not be allowed to walk.

3, when the broken hammer high pressure or low pressure hose has excessive loosening phenomenon, please stop working immediately and check and repair immediately. At the same time, for the sake of caution, it is advisable to check whether there is any oil leakage in other places. Operators should be strict in paying attention to the situation of the strike point.

4. Do not work in water or muddy ground. Outside of the drill rod, the other parts of the broken hammer should not be immersed in water or mud. Otherwise, the piston and other parts with similar functions will cause premature loss of the broken hammer because of the accumulation of mud.

5, the main body of the breaking hammer is a set of precision parts including hydraulic circulation system. Generally, the factories without special equipment do not decompose themselves, and must be entrusted with maintenance.

The working environment of broken hammer is poor, and a little carelessness will cause great harm to it. If the hammer is properly used, it will greatly extend its life. I hope to finish this article to help you!